After our last class we made some headway, and came to some obstacles. We got the basics figured out on the hardware end. Each sensor is hooked up and we’ve calibrated correct values for the correpsonding three measurments. Eg hot, average and cold for temperature. What we’ll need to do now is move the sensors from the breadboard to a remote location on our final wearable device. Our initial intention is to have the sensors placed appropriately around the wearable, all connect via wires to the aurdino which will be held somewhere on the jacket.
On the software front, we managed to generate a Haiku based on the sensor values. Each of the three sensor ranges corresponds to a specific line of the haiku, and depending on what the sensor reads, the haiku will be different. The next step will be to allow for a choice of line within each sensor range so that the haiku’s will be different everytime. This we have yet to tackle..
